← Back to all reviews

Home Cinema · Picker ·

Which projector fits your room? Answer three questions

The critic

A projector fits your room when its throw ratio matches the distance you have: distance = ratio × picture width. A 100 inch picture is about 2.2 m wide, so a standard projector wants roughly 2.4–3.3 m, and a short-throw one under 2 m.

Answer three questions to see which type fits, and how bright it needs to be for your room.

Picker · 4 min read

Buying a projector starts with a tape measure, not a spec sheet. Two numbers decide whether a projector works in your room: how big you want the picture, and how far back the projector can sit. Everything else (brightness, resolution, price) comes after. Answer three questions below and you get the throw distance you need, the kind of projector that fits, and how bright it should be.

The one number: throw ratio

Every projector has a throw ratio, printed in its specs as something like 1.2:1 or 0.69–0.83:1. It is simply the distance from lens to screen divided by the width of the picture. A ratio of 1.5 means the projector sits one and a half picture-widths back. A 100 inch 16:9 picture is about 2.2 m wide, so that projector wants roughly 3.3 m of room. A ratio under about 0.8 is called short throw: the same picture from under two metres, which suits a living room where the projector sits on the media unit just below the screen. Anything near 1.1 to 1.5 is a standard throw, which suits a coffee table or ceiling mount at the back of a typical lounge.

Many projectors have a zoom lens, which gives a range of ratios instead of one number. That range is your wiggle room: a 1.13–1.46 projector can fill the same screen from a fairly wide band of distances, which is very handy when the sofa and the shelf are not where you would ideally put them.

Brightness is about the room, not the film

Brightness is measured in ANSI lumens and it gets spread over the whole picture, so doubling the screen width quarters the brightness per square metre. A modest LED projector around 500 ANSI lumens can look lovely at 80 to 100 inches in a properly dark room and washed out the moment a lamp is on. Rooms with curtains and some glow want something in the region of 1,500–2,500. If daylight stays on, you are in the 3,000-plus club, and even then a projector is a compromise next to a TV. Be wary of marketing numbers on very cheap models: look for ANSI lumens, not just "lumens".

Check these before you buy

  • Measure from lens to wall, not from the back of the sofa. Include the depth of any shelf the projector sits on.
  • Look for lens shift or keystone correction if the projector will sit off-centre. Digital keystone fixes the shape but costs a little sharpness.
  • Think about the sound. Built-in projector speakers are fine for a bedroom and thin for a film. A soundbar is usually the next purchase.
  • Check the fan noise if the projector will sit near you; quiet models quote around 26–34 dB.
  • Your wall can be your screen, if it is smooth and light. A proper screen helps most when the room is not fully dark.

The picks below are three BenQ projectors at different price points, chosen because their throw ratios and brightness differ in the ways the picker above describes, so one of them is likely to match your answers. Prices vary by shop and day, so the picks show current ones.

Int. the prop room · continuous

Take it home

Affiliate links, marked sponsored. We may earn a commission at no extra cost to you. Picks that suit the film; products aren't scored. Prices checked 6 Oct; every shop is on each product page.

More Home Cinema:

Next scenes: